Output Configuration Tab - 1794-OF8I/A
Use this tab to configure each output channel of your analog output module.
Parameters
Channel
Configure the corresponding output channel.
Voltage/Current Range
Choose to configure the channel as
- None (default)
- 0 to 20 mA
- 4 to 20 mA
- -10 to 10V
Use NAMUR-compatible Current Limits
Displays only for channels configured with a 4 to 20 mA range. Click for output channels to be clamped to 3.8 mA minimum and 20.5 mA maximum.
OK
Click this button to accept your edits on any tab and close the dialog.
Cancel
Click this button to cancel your edits on any tab and close the dialog.
Apply
Click this button to apply your edits on any tab and continue editing.
If:
- you are online in Program, Remote Program, or Remote Run mode and,
- this controller is the owner controller and,controllerA device that controls machines or processes elements (for example, a programmable controller or relay panel).
- you have changed the module’s configuration in the software,
- when you click the Apply or the OK button, the information is automatically sent to the controller. The controller tries to send the information to the module (if the module’s connection is not inhibited). If you don’t click Apply, your changes are not sent to the controller.
Note that the connection to a FLEX I/O module using Rack communication cannot be inhibited. The Inhibit check box on the Connection tab is disabled in this case.
Help
Click this button for Help on this tab.
Provide Feedback