PowerFlex 700 Vector Control Communications over EtherNet/IP

Who Should Attend

Individuals responsible for commissioning PowerFlex 700 vector control drives on an EtherNet/IP network should take this course.

Prerequisites

To successfully complete this course, the following prerequisites are required:

• Working knowledge of electricity, and knowledge of electrical and industrial safety (including PPE requirements and safe practices)
• Completion of the PowerFlex 700 Vector Control Configuration and Startup course (CCA161) or equivalent experience
• Knowledge of Logix5000 system fundamentals and basic programming skills through one of the following methods:
  • Completion of the Studio 5000 Logix Designer Level 2: Basic Ladder Logic Programming course (CCP151)
  • Completion of available RSLogix 5000®/Studio 5000® software
• Equivalent on-the-job experience

Student Materials

To enhance and facilitate the students’ learning experiences, the following materials are provided as part of the course package:

• Student Manual includes the key concepts, definitions, examples, and activities presented in this course
• Lab Book provides learning activities and hands-on practice. Solutions are included after each exercise for immediate feedback.
• PowerFlex 700 Standard and Vector Control Procedures Guide provides all the steps required to complete common PowerFlex 700 tasks, including the tasks in the hands-on exercises. By following the procedures in this job aid, you can immediately apply what is learned in the course to your own job.
• Studio 5000 Logix Designer and Logix5000 Procedures Guide provides the steps required to complete basic Logix Designer application tasks that are common to all Logix5000 hardware platforms.

Hands-on Practice

Throughout this course, you will have the opportunity to practice the skills you have learned through a variety of hands-on exercises using the PowerFlex 700 AC Drive workstation (ABT-TDPF700). Exercises focus on the skills introduced in each lesson.

Course Agenda

• Adding a PowerFlex 700 Vector Control Drive to a Studio 5000 Logix Designer Project
• Importing PowerFlex 700 Vector Control Drive Control Code into a Studio 5000 Logix Designer Project
• Creating New PowerFlex 700 Vector Control Drive Control Code in a Studio 5000 Logix Designer Project
• Synchronizing Data and Testing PowerFlex 700 Vector Control Drive Operating Modes
• Configuring PowerFlex 700 Vector Control Drive Peer-to-Peer Communications
• Integrated Practice – Adding PowerFlex 700 Vector Control Drives and Drive Code to a Studio 5000 Logix Designer Project