- Studio 5000 Logix Designer
- Tasks, programs, and routines
- Add-On Instructions
- Controller Organizer
- Logical Organizer
- Alarms
- Tag-based alarms
- Tag Editor and Data Monitor
- Configure settings for Tag Editor and Data Monitor
- Equipment phases
- Equipment Sequences
- Equipment Sequence Diagrams
- Ladder Editor
- Structured Text Editor
- Sequential Function Chart Editor
- Define the steps of an SFC process
- PlantPAx instruction properties
- Controller Properties
- Editing Controller Properties
- Controller Security
- Source Protection
- License Source Protection for Routines and Add-On Instructions
- Module Information
- 1756 ControlLogix I/O Modules
- Instruction Set
Calibration tab parameters 1756 analog I/O
The table describes the parameters on the
Calibration
tab of the Module Properties
dialog.
ATTENTION:
Entering calibration mode causes all input channels to freeze at their current values and fault. Control may be impair
Parameter | Description |
Calibration Range | Displays the range in which the channel will be calibrated based on the current module selected. Calibration Range may also be fixed or dependant on the Input Range selected during configuration. |
Calibration Gain | Displays the calibration gain correction factor currently being applied to the channel. |
Calibration Offset (Counts) | Displays the calibration offset correction factor in DAC/ADC counts currently being applied to the channel. |
Calibration Status | Indicates if the existing calibration for the channel is considered bad. A calibration is considered bad if:
|
Start Calibration (available only when the controller is online) | Starts the calibration process. If you are using the 1756-OF4, -OF8, -IT6I, -IF6I or the IF6CIS modules for current or voltage applications, select the appropriate Output Range or Input Range on the Configuration tab on the Module Properties dialog box. |
Module Last Successfully Calibrated | Displays the date on which the module was last successfully calibrated. |
Provide Feedback