- Studio 5000 Logix Designer
- Tasks, programs, and routines
- Add-On Instructions
- Controller Organizer
- Logical Organizer
- Alarms
- Tag-based alarms
- Tag Editor and Data Monitor
- Configure settings for Tag Editor and Data Monitor
- Equipment phases
- Equipment Sequences
- Equipment Sequence Diagrams
- Ladder Editor
- Structured Text Editor
- Sequential Function Chart Editor
- Define the steps of an SFC process
- PlantPAx instruction properties
- Controller Properties
- Editing Controller Properties
- Controller Security
- Source Protection
- License Source Protection for Routines and Add-On Instructions
- Module Information
- 1756 ControlLogix I/O Modules
- Instruction Set
DANGER! About to Begin Calibration - Please Read Carefully!
- Calibration should not be performed on a module currently being used for control. The channels will freeze at their current values, and control may be interrupted.
- Calibration disrupts control involving the module.
- Calibration disconnects the module from the control signals to which it is normally connected and connects it to reference signals.
- During calibration, output modules do not update their outputs with the data values requested by the controller. Outputs may transition based on the calibration process itself if that channel is being calibrated.
- During calibration, the controller is not receiving measurements of signals, originating in the system under control, from the input module.
- Choose OK to continue with calibration.
- Choose Cancel to cancel startup of calibration and return to the Calibration tab.
Provide Feedback