- Studio 5000 Logix Designer
- Tasks, programs, and routines
- Add-On Instructions
- Controller Organizer
- Logical Organizer
- Alarms
- Tag-based alarms
- Tag Editor and Data Monitor
- Configure settings for Tag Editor and Data Monitor
- Equipment phases
- Equipment Sequences
- Equipment Sequence Diagrams
- Ladder Editor
- Structured Text Editor
- Sequential Function Chart Editor
- Define the steps of an SFC process
- PlantPAx instruction properties
- Controller Properties
- Editing Controller Properties
- Controller Security
- Source Protection
- License Source Protection for Routines and Add-On Instructions
- Module Information
- 1756 ControlLogix I/O Modules
- Instruction Set
Wiring Diagram 1756-PLS
Use the table below to connect the resolver and resolver connector to the 1756-PLS resolver module.
TIP:
This wiring yields increasing position with counterclockwise resolver shaft rotation (viewed from shaft). Switch the wiring to RTB terminals 14 and 16 to reverse direction.
Wiring Inputs
The example diagram below shows switches connected to the inputs on the left section I/O module.
Wiring Outputs
The example diagram below shows a solenoid connected to an output on the right section I/O module.
Provide Feedback