Configure programs

From the

Program properties

dialog box, select the

Configuration

tab.

Select the

Main

routine assigned to the program.

Select the

Fault

routine assigned to the program.

Select

Inhibit Program

to prevent the controller from executing this program. The option is cleared by default.

This option is disabled if the

Use as Folder

check box is selected on the

General

tab.

Select

Synchronize Redundancy Data after Execution

to synchronize data at the end of the program execution.

This option is disabled when:

the
Use as Folder
check box is selected on the
General
tab
when Redundancy is not enabled

This option does not appear for Safety controllers. The option is always enabled for controllers with Redundancy enabled as long as the controller is not in Hard Run mode.

Select

OK

to save the program properties.