Configure an isolated integer analog output module

Select the channel button for the channel that you want to configure.

Select the

Hold for Init

box if you want the module to hold the output signal unchanged until the output value (received from the controller) is within 0.1% of full scale of the value held.

Select the

Hold

button (under Fault State) if you want the output channel to remain at the last output value, OR

Select the down arrow (under Fault State) if you want the output channel to go to a specific value if the connection, to the owner controller, is lost.

Enter a value for the output to take upon fault in User Fault Value.

Select the

Ramp to Fault

box for each output point for which you want to enable ramping, at the ramp rate limit, from the current output value to the fault value (when a fault occurs).

Select the

Hold

button (under Program State) if you want the output channel to remain at the last output value, OR

Select the down arrow (under Program State) if you want the output channel to go to a specific value if the owner controller is switched into program mode.

A

User

button appears. Select the

User

button.

Enter a value for the output to take, when the module enters program state, in

User Program Value

.

Select the

Ramp to Program

box for each output point that you want to enable ramping, at the current rate limit, from the current output value to the program value (when a program command is received from the controller).

Enter the maximum rate of change in the output signal for each output point, in counts per second, in

Rate Limit

.

Select

OK

to save the changes to close the dialog.