Configure output states on a analog output module - floating point

Create a channel-level configuration specific to your application.
To configure the output states on an analog output module (floating point):
    1. In the
      Controller Organizer
      , right-click the module and select
      Properties
      .
    2. In the
      Module Propertie
      s dialog, select the
      Output State
      tab.
    3. Select the
      Channel
      button to select the channel to configure.
    Under
    Output State in Program Mode
    , select how the output channel reacts when the owner controller is switched to Program mode:
    • Hold Last State.
       The output channel to remains at the last output value.
    • User Defined Value.
       The output channel transitions to a user-specified value.
      IMPORTANT:
      If you select
      User Defined Value
      , enter a value in the box and select
      Ramp to User Defined Value
      .
  2. Under
    Output State in Fault Mode
    , select how the output channel reacts if a fault occurs:
    • Hold Last State.
       The output channel remains at the last output value.
    • User Defined Value.
       The output channel transitions to a user-specified value.
      IMPORTANT:
      If you select
      User Defined Value
      , enter a value in the box and select
      Ramp to User Defined Value
      .
    1. Select
      Apply
      to save the changes and continue editing, or select
      OK
      to save the changes and close the dialog.
Provide Feedback
Have questions or feedback about this documentation? Please submit your feedback here.