Advisory Alerts

An Advisory is generated when a failure is expected to occur within a certain time period, typically this is within 21 days. The Advisory contains information about the potential failure, including diagnostics and recommendations on how to validate and address the detected potential failure. Additional data is provided for context, a Snapshot tab allows user to view the current state of all the variables when the advisory was generated, and a Trend tab to allow user to analyze the advisory in more detail as required.

Advisories are generated on Asset Components. The following tabs are displayed in the advisory alerts:

In the

Overview

tab, there are four different sections such as Advisory Diagnostics, Advisory Summary, Advisory Action, and Work Order.

The

Advisory Diagnostics

section provides information about the potential failure, including the diagnostic and recommendations on how to validate and address the detected potential failure. If previous Diagnostics are provided on this component and it is displayed in the

Previous Diagnostic Details

section.

The

Advisory Summary

section provides advisory summary details along with current, and future risk scores and remaining useful hours of KPIs.

In the

Advisory Action

section, with appropriate user privileges, the user can change the status of the Status, Add Comments, and Upload associated files.

In the

Work Order

section, the user can create work order number, change status and add comments to the work order.

The

Work Order

section allows for the manual tracking of the associated Work Order required for the action of the alert.

In the

Trends

tab, the user can view all associated parameters to the Component to do further analysis. The user can use the Select Parameter, Frequency, and Aggregation drop-down lists to filter the data.

In the Trend, the user can view the Trend at the top and a sparkline view at the bottom. The user can change the date selection by using the selectors of 1/3/6 months, year to date [YTD], 1 year, and all. The user can use the sliding selector at the bottom to change the date selection.

Hover over the trend chart to view the parameter value with the corresponding date and time details.

The snapshot shows the condition of each sensor relative to the Advisory Threshold Limits at the time of the triggered Advisory.

There are two different types of Sensors Physical and Virtual as defined during the Asset Setup. The timestamp is provided as a starting point for additional investigations.